Messages

11

General Mach Discussion / Re: please help

« on: September 25, 2012, 06:09:48 AM »

Thanks Hood,


I do not call it anything  i just write M6 and do not use offsets or toolnrs

just need an optional  programstop

12

General Mach Discussion / Re: please help

« on: September 25, 2012, 04:26:58 AM »

Nobody ?

13

General Mach Discussion / Re: please help

« on: September 22, 2012, 05:32:04 AM »

Hi Hood, thanks for the reply

I am using Turn and Yes i have M6Start.m1s and M6End.m1s


Mark

14

General Mach Discussion / Re: please help

« on: September 21, 2012, 05:23:56 AM »

I need Machturn to stop at m6 and start again after cyclestart ( just for the interruptiion no actual toolchange ) but it doesnt.

If unchecked the ignore-setting. and seem to lack the file M6.M1s  is there anywhere i can download this file?  (i am not much of a scriptwriter myself)


Thanks
Mark

15

General Mach Discussion / errormessage

« on: April 06, 2012, 09:22:49 AM »

Would like to use threadcuttingoption  in Mach3Turn but after several tries still no succes.

Now i am making a new attempt , installed Windows7-32bit and Mach3turn latest lockdown version.

After starting mach3 i get an empty machscreen and the message:

  no access to last errors.txt

Anybody any clues?


thanks
Mark

16

General Mach Discussion / Re: mach3 loses contact

« on: March 23, 2012, 11:39:34 AM »

Thanks Hood, i have deleted all my in and outputs and this cures my problem .

So i only have to find out which one is faulty.

Thanks again
Mark

17

General Mach Discussion / Re: mach3 loses contact

« on: March 23, 2012, 07:00:41 AM »

Jogpendant JW-2 from cnc-steuerung in germany it uses a scriptfile should is disable this scriptfile?

do not know what you mean by probeinput, and how to disable

18

General Mach Discussion / Re: mach3 loses contact

« on: March 23, 2012, 06:53:23 AM »

I removed the Jw2 hardware ; no effect

19

General Mach Discussion / Re: mach3 loses contact

« on: March 23, 2012, 06:42:31 AM »

In Diagnostics:   no messages when jog attempt


leds :      port1pins:       #1#2#3 5#6#7#8   #12  are lid    #4 flashes
           inputsignals:      #1#2#4 are lid

Inp1    led is  flashing
Digitize  led is  flashing

time in int +4.5-+5.7

20

General Mach Discussion / Re: mach3 loses contact

« on: March 23, 2012, 04:47:35 AM »

used an older xml but to no effect.


I use 2 different Mach3-softwareprogs:  Mach3Turn for my lathe and Mach3Mill for my mill.
Its on  1 Pc with 1 breakoutboard to 3 stepperdrives .
I have made some provisions for a output-hardwareswitch from  2 drives for X/Z to my lathe and  3 drives X/Y/Z for my mill .


When i start up M3Turn for my lathe and leave the Hardwareswitch to the Mill so the output from M3Turn goes to  Mills  X and Z axis , then jogging works ok