Hello Guest it is March 28, 2024, 12:51:58 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - fercho41890

Pages: 1
1
General Mach Discussion / Re: Help with mach 3, starting cut position
« on: March 08, 2024, 07:36:08 AM »
I put the 0 of the piece on one end in the center, I know that at mach 3 I have to indicate the radius of the piece, but when I go to mach 3 and tell it where the 0 of my piece is, when it starts cutting instead of starting where I gave it 0 it moves to the side and starts and apart from that it starts cutting the piece as if it were placed horizontally, and I have it vertically as you can see in the photo. I'm attaching fusion file to see if you can help me with that.
My big problem here its the starting positing when im gonna cut.

2
General Mach Discussion / Help with mach 3, starting cut position
« on: March 07, 2024, 05:57:04 PM »
i made a model on fusion 360 to practice with 4 axis, and i cant get the correct position to start the cut, i tried everything, also i dont know if my post proccesor its good for 4h axis, i attached a picture of the work space and the position and the nc code file, the fusion file cant attach it. If someone can help me i can send you the fusion 360 file to see if my error its there.

3
General Mach Discussion / milling problem mach 3
« on: June 04, 2020, 08:49:14 PM »
hi, im starting with milling cnc, my issue is i create the cam on fusion 360 without problems and set the start point when im in the mach 3 i set the same offset as in fusion 360 but it doesnt work it always appear backwards and dont know why

Pages: 1