Hello Guest it is October 05, 2022, 06:35:33 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Alchematic

Pages: 1
1
Hi Tweakie.

Thanks for the reply.

Yes I understand that it is a steady state High and Low dependent on direction.

Researching this more yesterday, I came up with this..

Ethernet Smooth Stepper puts out Z axis Move Pulses on pin 6 and Direction on Pin 7

I want to access that Pin 7 signal.

I thought I might do it in hardware with a DB25 male to female with breakout and jump pin 7 to the Pin 9 which would give me that direction signal on the MX3660 CN7 digital output 4

I might have to break the normal/ circuit trace from the pin 9 of the input DB25 to avoid conflict.

I am checking with Warp9 to make sure that Z Axis Direction pin 7 can feed 2 input without loading. It should.

Then I got to looking at Mach 4 and the ESS setup. There is a new feature where you can assign Output signals to multiple pins.

This is done on the ESS Configuration App and Output Signals tab.

So I am hopefull that I can just send the Z Axis direction to Pin 7 as is normal and to Pin 9 to feed the MX3660 digital out 4


2
I am setting up a new system for an old engraving table. Using Mach3 thru ethernet smooth stepper to leadshine mx3660 and to steppers for x and y axis.

The z axis is a air actuated spindle by New Hermes for fine engraving.

I need to turn on a relay driven air valve solenoid when the z axis starts a plunge or downward motion and off when the z axis retracts. The action of the plunger is fast.

There is of course no z axis stepper motor. I just need a logic signal on an mx3660 output that corresponds to the direction a z axis stepper would move if there was one.

Is there any way to set up an initial line of code that would output this logic.. Logic high when z axis is plunging (down) and Logic low when z axis retracts (up) 

Logic polarity is of no concern. I can set that up with hardware.

I am most likely gong to use Vcarve to generate gcode but they do not have a solution for this so far.

Thanks

Mark


Pages: 1