Hello Guest it is March 31, 2023, 05:43:12 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - 548cidakota

Pages: 1
PoKeys / Re: POKEYS57CNC and Mach4 Homing Switches
« on: May 20, 2020, 04:40:05 PM »
Curious what you found out with your homing issues with your Pokeys57cnc. I am having issues homing mine as well. All my negative limits are seen and functioning, but none of my home/limit switches are not even registering. I have confirmed my wiring multiple times, but still cannot resolve it. In the diagnostics tab, the end limits will appear when activated, but it wont acknowledge my home/limits. Its like they are not even connected. I have tried both the ribbon connector and and the limit screw pin terminals on the board and still nothing.

Any tricks you could give me would be greatly appreciated.


Pages: 1