Messages

11

General Mach Discussion / Re: Setup and Control issue

« on: May 06, 2020, 11:01:01 AM »

Bumping up. I didn't have my old config file and set this up from snapshots from my previous machine. Can't seem to figure this out. Switching ports and pins around I was able to replicate it on the x axis, so It's not the engines. Any help is appreciated.

12

General Mach Discussion / Setup and Control issue

« on: May 05, 2020, 08:41:24 AM »

Hi. Returning after many years. Setting up Mach on a new machine and I'm having trouble with the Y axis. It will jog when I press the up arrow key, but won't stop. If I reset and jog in the opposite direction, it will start/stop , but only in that direction.  X and Z function fine. Windows7, parallel port/Gecko 540/Nema 23