Hello Guest it is April 16, 2024, 01:57:27 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Maxxk9

Pages: 1
1
General Mach Discussion / Mach 3 4th axis display
« on: March 19, 2020, 08:26:10 PM »
I am setting up a rotary axis on my plasma cutter for tube profiling. Unfortunately,  I cannot figure out how to get Mach 3 to show the 4th axis on the screen. I have finished enabled and configured the A axis, but it will not show on the main screen. Any ideas?

Pages: 1