Hello Guest it is March 28, 2024, 04:28:16 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ronald4418

Pages: « 1 2 3 4 5 »
11
General Mach Discussion / Re: Newbie Problem
« on: February 03, 2011, 07:05:54 PM »
Thank you very much for your quick response.

12
General Mach Discussion / Newbie Problem
« on: February 03, 2011, 06:31:18 PM »
Whenever I open Mach3, I end up with an error message that states " Initialization Macro called upon reset". What is it and how do I rectify the problem?

13
Mach3 under Vista / Initialization Macro Called on Reset?????
« on: January 21, 2011, 07:02:04 AM »
I just performed a new install of Mach3 and every time I try to run it I get this as a result. It will run until it hits any M code and the stop. Can anyone tell me as to what it is that I am doing wrong?
 I'm only using Mach3 on this Vista System to check my code before sending it to my Windows XP system which controlls my mini-mill.

14
General Mach Discussion / Re: Download Servers
« on: June 17, 2010, 04:06:09 AM »
I've tried to download now on a dsl setup as well as a T1 and a T4 setup all to no avail. After initializibg the downloads, they always stall and drop down to the point where there is no distinguishable download rate. I've tried back-tracing to see if there is a bottle neck that's holding up the downloads and it seems to start and end at your servers.

15
General Mach Discussion / Re: Download Servers
« on: June 11, 2010, 11:34:05 AM »
I've tried Chrome, IE8 and Opera 10.10 all with the same results. It'll download only a portion of the file. Then it'll hang and then tell me that I'll have to wait upto 20 hours to download the latest update.

16
General Mach Discussion / Re: Download Servers
« on: June 11, 2010, 08:58:28 AM »
What browser are you using? I get the same response with IE 8. It downloads for a few seconds and then hangs, regardless as to whether I use FTP or Http/

17
General Mach Discussion / Re: Download Servers
« on: June 10, 2010, 11:51:32 PM »
I just noticed that downloads are being listed as 2.5 kb's per second.

18
General Mach Discussion / Download Servers
« on: June 10, 2010, 11:49:14 PM »
Is there a problem with download's now? I was trying to update to the newest version and the download would stop after downloading anywhere between 2 and 31% of the usual 25.6 mb's.

19
General Mach Discussion / Re: Downloads
« on: November 25, 2008, 03:03:13 PM »
Yes, thank you.

20
General Mach Discussion / Re: Downloads
« on: November 25, 2008, 02:55:22 PM »
Seems that if you click run it will hang, but if you click save it takes around 30 seconds with a high speed dsl modem.

Pages: « 1 2 3 4 5 »