Topics

1

General Mach Discussion / Carbide Create with Mach 3

« on: December 08, 2019, 03:22:06 PM »

I have created a simple engraving GCode file using Carbide Create.  I load it into my Mach 3 and can see the cutter paths in the display.  When I run it it seems that the machine movements are very small, not to any scale.  I previously was using CATIA for my gcode but is was very complex and I felt the Carbide Create would be easier.  I am looking for any help or advise on this problem or even suggesting a better cad gcode generator.