Hello Guest it is March 28, 2024, 08:04:46 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jeffmklein

Pages: 1
1
General Mach Discussion / Re: Carbide Create with Mach 3
« on: December 09, 2019, 09:23:27 PM »
I downloaded the F Engrave and found it to be very easy to use.  I created a quick gcode and loaded it into my Mach3.  It still seems to be running very “small” compared to the size of the .5” tall letters.  I am stumped.  I thought maybe there was some Metric unit conversion fouling up the run but I can not find anything.

2
General Mach Discussion / Carbide Create with Mach 3
« on: December 08, 2019, 03:22:06 PM »
I have created a simple engraving GCode file using Carbide Create.  I load it into my Mach 3 and can see the cutter paths in the display.  When I run it it seems that the machine movements are very small, not to any scale.  I previously was using CATIA for my gcode but is was very complex and I felt the Carbide Create would be easier.  I am looking for any help or advise on this problem or even suggesting a better cad gcode generator.

Pages: 1