Hello Guest it is March 28, 2024, 09:52:34 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - otpco

Pages: « 1 2 3 4 5
41
General Mach Discussion / Re: Digispeed not working
« on: March 25, 2012, 07:51:52 AM »
I have been reading some of the old posts now dont even know my own name . Peter will be along to save us I hope .I cant see anything will walk away for a while and come back to it

42
 how good is the Myford bed .Is it worn .Myfords have a habit of shying away from work with there flat bed design .  I used to have one and found that a couple of zero cuts helps . I now run Hercus/Southbend . And find  heaps better . give it a go

43
General Mach Discussion / Re: Digispeed not working
« on: March 22, 2012, 06:28:30 AM »
Theree must be somthing wrong with us here in Canberra 3 of us and none of us can get them to work .I am going to build a test system so we can all have a play with it

44
General Mach Discussion / Re: Digispeed not working
« on: March 20, 2012, 06:44:25 PM »
Just ordered some spare parts for us all . with a few of us up here using the same boards it might be handy .Thinking of traping peter and keeping him here for a few days . Lets build a trap !!!

45
General Mach Discussion / Re: Digispeed not working
« on: March 20, 2012, 06:17:06 PM »
Man I hope this works ! its sending us nuts here in the capital !

46
General Mach Discussion / Re: Help sinking ! Breakout board testing
« on: March 16, 2012, 06:25:47 PM »
Yes thanks I think I have a board malfunction or opperator !! Trying to work what lights mean what ! thanks for your time still working on it

47
General Mach Discussion / Help sinking ! Breakout board testing
« on: March 15, 2012, 07:37:51 AM »
Hi all I am in need of some help . I have a CNC4PC Parallel port Interface board C1 .I need to test it . I have the 5 volt supplyes and the enable connected .I have a bunch of lights going . Does a light come on when its enabled ? I cant seam to get anything through the board .Is there any easy test ? The machine has been in storage for a while .It did work . it goes from this board to my Rutex 990 boards . I have this so I can run my digi speed 03 without cutting the parallel port cable .( I am old and those ity bitty wires give me the s--ts ) any ideas would be good thanks otpco 

48
General Mach Discussion / encoaders
« on: April 07, 2006, 07:36:33 PM »
what do you guys think of this .I would like to get it right the 1st time if possable bridgeport Moog 4=1 reduction on ballscrew on table servo motor now the problem encoders !! us digital differential type . what resolution ? and can I mount them on the screw rather than on the back of the motor ? greetings to all from downunder

Pages: « 1 2 3 4 5