Messages

11

General Mach Discussion / P I D tuneing of servo motor

« on: September 16, 2014, 05:32:21 AM »

 Hi all I have had a Crash and cooked the servo motor drive . Bugger .  I am looking for some information about PID tuning .   IT used to be here but the search turns up nothing . I need a  easy Guide to how to do it thanks Otpco .

12

Tangent Corner / Mist coolant

« on: January 28, 2014, 11:33:50 PM »

Hi all I want to try mist type coolant . Is there any how to stuff out there I like the Spra-kool but at 78.00 postage its a bit rich !!!! . Think it looks great a hole lot less mess than flood type . This is for my Moog Hydropoint . conversion thanks to alll

13

General Mach Discussion / Re: Spindle parking with mach ideas please

« on: January 04, 2014, 06:01:57 AM »

it has to be  pretty good by the look of it a degree oso either way . thinking of a roller and well maid cam balanced etc . hop I have not hafve to grind it ! the machine is old but done no work . Bridgeport Moog . have had it going for some years but would like to get the tool changer in on the act .

14

General Mach Discussion / Re: Spindle parking with mach ideas please

« on: January 04, 2014, 04:45:50 AM »

thanks yhinking of a heart shaped cam and roller plunger

15

General Mach Discussion / Spindle parking with mach ideas please

« on: January 03, 2014, 02:26:41 AM »

Hi all i have a Mood bridgeport mach conversion up and running . i would like to try to get the tool changer up and running . I need some ideas on parking the spindle . I run a VFD and speed control for the spindle . Will the all singing and dancing Mach 4 be able to help me > I have worked out most of the control but the spindle is giving me trouble any ideas thanks to all Mark Sunny Australia 36 C here today

16

Third party software and hardware support forums. / OT Moog Parts needed

« on: July 02, 2013, 03:41:43 AM »

Hi all I Have an old Bridgeport Moog Converted to Mach .I have had a drawbar falure and need some parts Has anyone seen or heard of a parts cow . thanks Mark Sunny Australia

17

General Mach Discussion / Re: Spindle RPM feedback, not low enough.

« on: April 06, 2013, 09:26:51 PM »

any luck with it yet

18

General Mach Discussion / Re: Spindle RPM feedback, not low enough.

« on: February 13, 2013, 07:29:53 AM »

Any reply from Homman re the board wireing . I think I am having the same type of problem 

19

General Mach Discussion / Re: Spindle RPM feedback, not low enough.

« on: February 02, 2013, 05:49:43 PM »

Katoh have you heard from Peter yet

20

General Mach Discussion / Re: Spindle RPM feedback, not low enough.

« on: January 26, 2013, 09:34:33 PM »

I will be looking forward to Peters reply .