Hello Guest it is January 28, 2020, 01:17:47 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - carlthomsen

Pages: 1
1
CS-Lab / Re: CSMIO/IP-M and Mach3 Enable output issues
« on: October 08, 2019, 04:43:57 AM »
The Enable output in Mach3 lights up.

2
CS-Lab / CSMIO/IP-M and Mach3 Enable output issues
« on: October 08, 2019, 04:25:17 AM »
Hi,

I'm trying to connect a Clearpath SDSK servo which requires a enable signal from Mach3 to energize it.

I have hooked up +24V to Pin9 and 0V to Pin22 (power for the outputs).

I'm using Output0 (Pin10) on the CSMIO and Port10 as the port.

I don't get any output signal. What am I missing?



Cheers,

Pages: 1