1
General Mach Discussion / Mach3 RnR motion card - problem with plasma relay
« on: August 16, 2019, 02:21:55 PM »
Hello everybody.
I am quite new to the CNC world and i have a problem with my setup on my plasma machine.
I use a chinese RnR motion usb Card with Mach3
I had managed to setup motors and all,
the problem i have is that i cant manage to get the torch to open. I use a simple relay. I had setup the output but nothing changes and the card doesn't give any indication it gives any signal.
in the diagnostics output1 has a red led when i turn on it manualy
I dont use a THC.
any suggestions?
I am quite new to the CNC world and i have a problem with my setup on my plasma machine.
I use a chinese RnR motion usb Card with Mach3
I had managed to setup motors and all,
the problem i have is that i cant manage to get the torch to open. I use a simple relay. I had setup the output but nothing changes and the card doesn't give any indication it gives any signal.
in the diagnostics output1 has a red led when i turn on it manualy
I dont use a THC.
any suggestions?