1
General Mach Discussion / Re: Mach3 aggressive motor movement stalling the motor
« on: May 26, 2019, 04:16:23 AM »
There is only one G0 in the beginning. Then it is G1 etc. The code is quite long, so I don't know if posting it all helps?
I am quite fed up with the situation so I installed yesterday Mach4 to test it out. There are strange symptoms, the motors stall/pause and make bad noise in the middle of the moment in all axes. Earlier the X and Y have performed flawlessly. I haven't got time yet to search any information about that yet, I only tried the delay setting in the motor config but it didn't stop that. It got better but still motors stalled. So there must be something I haven't figured out yet. Also the demo timeout stops testing too soon so it does not help either.
I am quite fed up with the situation so I installed yesterday Mach4 to test it out. There are strange symptoms, the motors stall/pause and make bad noise in the middle of the moment in all axes. Earlier the X and Y have performed flawlessly. I haven't got time yet to search any information about that yet, I only tried the delay setting in the motor config but it didn't stop that. It got better but still motors stalled. So there must be something I haven't figured out yet. Also the demo timeout stops testing too soon so it does not help either.