1
General Mach Discussion / Re: Mach 3 and Price CNC
« on: February 24, 2020, 10:52:07 PM »
Howdy,
yes i did finally get it figured out. took some trouble shooting but got it. the setup did change from the manual that cam with the controller. this is how mine is setup. hope it helps.
Torch on enable green check port 1 pin 13 active low green check
THC up enable green check port 1 pin 12 active low green check
THC down enable green check port 1 pin 11 active low green check
yes i did finally get it figured out. took some trouble shooting but got it. the setup did change from the manual that cam with the controller. this is how mine is setup. hope it helps.
Torch on enable green check port 1 pin 13 active low green check
THC up enable green check port 1 pin 12 active low green check
THC down enable green check port 1 pin 11 active low green check