31
General Mach Discussion / Re: Motors stalling /growling
« on: May 10, 2019, 08:53:11 AM »
After setting motor tuning to your recommendations fine tuning (X axis) , its the best its done but i can run the mach 3 demo maybe 3 times without any problems but the next 3 times it will stall or have what sounds like vibration. it does it at no certain place in program. Check the volts while running nothing drops. When motor is running for several seconds in program without changing directions , the motor sounds like it is changing rpms, not a lot but just enough to hear. I tried the Y and A axis without any success. After trying Y and A and going back to the X axis had to fine tune again.