Hello Guest it is March 28, 2024, 09:41:43 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - stell

Pages: 1
1
General Mach Discussion / Basing on limit switches
« on: October 16, 2021, 01:33:29 PM »
what could be the reason that after hovering over the limit switch I cannot leave it, despite the enabled option: Auto Limit Override?

2
General Mach Discussion / Strange behavior of mach3
« on: October 13, 2021, 02:43:08 PM »
I had to reinstall macha3 because it stopped working / no contact with the machine /, after that the behavior of the motors and one servo changed, although the values ​​in the tab where you set the parameters of the motors - no, they remained the same. Before this installation, I overwritten / thought this would help /, the <MACH> folder that was long saved with different settings and now everything has changed. Could this overwriting of the <MACH> folder with an older copy contribute to this?
I heard that even after a new installation, MAch remembers some settings.

3
Mach SDK plugin questions and answers. / zero detail
« on: April 22, 2019, 05:49:20 AM »
Hello,
Could someone help me write a macra used to set 0 details?

Pages: 1