Hello Guest it is June 02, 2023, 02:06:15 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Chuck D

Pages: « 1 2 3 4
General Mach Discussion / Re: New guy frustration LOL
« on: April 02, 2019, 02:27:02 PM »
Attached is Tool Probe VB code I use (but I use with Parallel Port).
You need to change 2 Z values to suit your plate thickness and retracting height (commented in RED)
Or get the idea and edit the code you already have.


Thank you... I think thats the one I have now, But I will try and compare it.

General Mach Discussion / Re: New guy frustration LOL
« on: April 02, 2019, 09:45:53 AM »
I have a Mach 3 motion controller called WHHC MKX-IV. Runs thru the USB

General Mach Discussion / New guy frustration LOL
« on: April 02, 2019, 09:13:41 AM »
I am new to the forum new to CNC and new to mach3 so here I am.
I bought a machine and I am now trying to configure mach3 and I am moving along slowly and having troubles with my probe/ touch plate.
Right now I am looking for a new script that will enable me to use the touch plate. The one that I got from YouTube seemed to work but it would send my spindle 6in off the material surface and when I tried to run code it ran the code 6 in off the work surface. So I want to find a new script and see if that was the issue.
any and all help is appreciated and I will do my best to learn to navigate the forums as soon as possible thanks for your patience and help.
I am in the United States. Mid Michigan to be exact

Pages: « 1 2 3 4