Hello Guest it is March 28, 2024, 12:34:43 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - wandler

Pages: 1
1
I hate buying something and it not working. I wanted this simple USB to connect a laptop to projects. SO I spent days reading and trying to get it to work...And voila consistent working red and blue usb boards. HOW DID YOU DO IT YOU ASK??? I literally followed directions.
You must load MACH 3 uncheck device driver that doe the LPT port. DO NOT START ANY SOFTWARE  copy RNR driver to plugin folder.

SHUT DOWN COMPUTER

Start computer

If you have the xml file from searching the web for the mill copy it into mach3
use MACH3 loader create new mill name using xml
start new mill xml
test reset if it stops flashing you did it in the correct order

if no worky uninstall mach3
delete mach3 folder and start over.

I was able to get my red and blue usb boards to work on windows 7,8,10,1064
I load an SSD in an old laptop and it is lightning fast boots in 4 seconds after you shut off the 24 windows intrusion of your privacy system controls. You have to shut off all the software security crap all the user interogation software all the web blocking web security crap and just shut off wifi when running system so it isn't interupted when machining.

I use 4 different pendants a bit of configuring since I do it through USB and wireless usb setting up my button controls. I have also used pendant wired to board

Pages: 1