Messages

11

Mach4 General Discussion / Re: XHC Mach4 USB motion board warning and info

« on: January 10, 2019, 06:19:52 PM »

May I ask how did you hook up the VDF to XHC  to control the spindle speed and your Mach4 config for it??
Thanks in advance

Laz

12

Mach4 General Discussion / Re: XHC Mach4 USB motion board warning and info

« on: January 09, 2019, 06:36:46 PM »

I'm pretty new at this as well. Got one of these XHC cards . I was able to set it up and used it for about 8 months now .
Never tried any of the outputs yet but I had a hard time with the input side of the controller the numbering was out so it took a lot of experimentation to get it going.
now it seems to be fine but still have issues, like spindle speed control. tried everything already but I can't get the 0-10V out of it .
been working at it for three months already and nothing I can come up with seems to work
Anyone knows how to get it working??

on the Mach4 side I broke some tooling due to the inch metric problem too

LAZ