1
Mach4 General Discussion / Re: Mach4 stops responding
« on: May 02, 2020, 08:00:32 PM »
Thanks Craig.
I tried a different G Code file and used the Fanuc post processor . It ran perfect no hangups
You were right the G code must have hung up .
But i noticed something else the m6 tool change script has a message box to tell you to change the tool and that message box sometimes appears under the main window so you can't see it and it makes it appear that mach is not responding
Cant click the ok button if you cant see it . If i minimize the main window it becomes visible , click ok and all is fine again.
Is there a way to make sure it is always on top
I tried a different G Code file and used the Fanuc post processor . It ran perfect no hangups
You were right the G code must have hung up .
But i noticed something else the m6 tool change script has a message box to tell you to change the tool and that message box sometimes appears under the main window so you can't see it and it makes it appear that mach is not responding
Cant click the ok button if you cant see it . If i minimize the main window it becomes visible , click ok and all is fine again.
Is there a way to make sure it is always on top