Hello Guest it is September 19, 2020, 07:02:37 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Blugreen

Pages: 1
1
General Mach Discussion / X Axis clunking - Skipping Steps
« on: March 17, 2019, 10:27:26 PM »
Hi.

I have a 3 axis CNC that I have just built using Nema24 Steppers on all Axis.  The X axis has 2 steppers slaved via Mach3.

All axis work fine except X.  It seems to miss steps (you can see and hear it) in a certain direction while running a program.  I can't replicate it while jogging.

The unit uses Mod1 Racks with 20T gears for both X and Y.

Does anyone have any ideas?

Thanks in advance.

Mark

Pages: 1