Guest
Show Posts
1
General Mach Discussion / Mach3 Demo only reading 500 lines of code?
« on: December 31, 2018, 11:19:53 AM »
Hi,
I'm having an issue with my tool path not showing up in Mach3 Demo version. I've read that the Demo version will only read 500 lines of code. Is this true? I've purchased some files to use and I would be willing to bet they're over 500 lines of code. Not sure if I want to invest in the licensed version until I know it can do the job. Any information on the Demo/Licensed version would be appreciated. Very frustrated here. The tutorials on the table site didn't say there was a line limitation on the Demo version.
Thanks,
Beve
I'm having an issue with my tool path not showing up in Mach3 Demo version. I've read that the Demo version will only read 500 lines of code. Is this true? I've purchased some files to use and I would be willing to bet they're over 500 lines of code. Not sure if I want to invest in the licensed version until I know it can do the job. Any information on the Demo/Licensed version would be appreciated. Very frustrated here. The tutorials on the table site didn't say there was a line limitation on the Demo version.
Thanks,
Beve