21
Mach4 General Discussion / Re: Mach 4 not stopping at manual tool change
« on: January 01, 2019, 04:44:39 AM »
Its actually more related to the M1 command in this case it seems, Mach4 has a "optional stop" toggle button.
I switched this on and it stops the program as Mach3 used to.
Seems I need to change my post processor to output M0 instead of M1 which is a mandatory stop and I dont have to worry about having the "optional stop" switch turned on.
I did sus out that "setting in Configure/Control/Tools and write your code accordingly." Though thanks
I switched this on and it stops the program as Mach3 used to.
Seems I need to change my post processor to output M0 instead of M1 which is a mandatory stop and I dont have to worry about having the "optional stop" switch turned on.
I did sus out that "setting in Configure/Control/Tools and write your code accordingly." Though thanks