Messages

11

Mach4 General Discussion / Re: Creating M-Code to activate Outputs

« on: August 07, 2019, 11:50:27 PM »

I tried running it and the M code did not do anything.  I opened it up in the editor and hit (start debugging) and it said C:\Machhobby\ZeroBraneStudio\bin\lua53. exe: error loading module 'machip' from file 'C:\Mach4hobby\Modules/machip. dll' :  the specified module could not be found.

12

Mach4 General Discussion / Re: Creating M-Code to activate Outputs

« on: August 07, 2019, 12:02:03 AM »

Hi Craig, thank you very much.  It looks Greek to me.  So if I copy that and just change OSIG_OUTPUT1 to OSIG_OUTPUT2 and the m101's to m102's I can control 2 outputs and so on?

13

Mach4 General Discussion / Re: Creating M-Code to activate Outputs

« on: August 06, 2019, 10:44:29 PM »

As part of the Goode

14

Mach4 General Discussion / Re: Creating M-Code to activate Outputs

« on: August 06, 2019, 09:13:14 PM »

Hi Craig,
 Thanks for your response.  That is more complex than what I am looking for all I want to do is create an M-code that will turn on/off outputs.  But I am not understanding how to create them. If I could be given an example of one then I could learn from what they did.

15

Mach4 General Discussion / Creating M-Code to activate Outputs

« on: August 06, 2019, 03:14:47 PM »

Hi I am putting together a machine that requires a number of outputs,  I have figured out how to turn them on and off using buttons on the screen,  but I cannot turn them on in the program.  I tried learning how to create an M-code in Mach4 Scripting Manual but it is not helpful for someone of my caliber.   If you can help me make one that will work I can copy and make the changes for the additional outputs.    I attached my feeble attempt, but it did not work (See attached)   I noticed that there were M-codes that turned on/off outputs (M200-M228) but that did not seem to work.  Any help would be appreciated.   I am using Mach4 and Pokeys 57E

Jeff