Hello Guest it is September 19, 2020, 06:44:31 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Sub001

Pages: 1
General Mach Discussion / Re: Calibrating spindle reversed?
« on: December 23, 2018, 02:07:21 PM »
I'm having the same problem with NVMC6 2.1, RPM % control gives me opposite reaction of spindle speed (100%->OV on breakout board, 0% gives me 10V).
Any idea on how I can correct that?

Pages: 1