1
General Mach Discussion / Re: Mach3turn tool table is making me crazy
« on: February 07, 2019, 06:40:36 AM »
Thanks for the anwsers, I was a few weeks on vacation so because of that my late respons.
My tool setup, already have shortened the tools. For touching off the tools I am using a 45mm bar.
I use my machine zero point for T0. I want to use T1 master tool just as my tool number one, possible or not?
For touching off the tools I just bring the tool to position and click on touch X or Z. Still the values doesnt make any sense after I have done that.
Just tried to touch off T1 and T2
Probably I am still doing something wrong but it is getting super annoying. Is it because T1 is not allowed to use as usable tool?
My tool setup, already have shortened the tools. For touching off the tools I am using a 45mm bar.
I use my machine zero point for T0. I want to use T1 master tool just as my tool number one, possible or not?
For touching off the tools I just bring the tool to position and click on touch X or Z. Still the values doesnt make any sense after I have done that.
Just tried to touch off T1 and T2
Probably I am still doing something wrong but it is getting super annoying. Is it because T1 is not allowed to use as usable tool?