Hello Guest it is November 12, 2019, 07:31:39 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - TimiSchor

Pages: 1
1
dspMC/IP Motion Controller / Re: PID Settings for Brushed DC Motors
« on: December 20, 2018, 01:28:11 PM »
Hello...in my case I was able to wire my throttle signal by making a Y harness for the signal wire as you described and my system runs! This is on a light weight ebike. But I had a bit of a struggle at first and I was wondering if you have a solution? The second controller I used came with a throttle that has a Cut/Kill button and a battery meter light.

Pages: 1