116
« on: July 27, 2006, 04:43:22 PM »
Chip,
As quickly as it sprang up, it disapeared, all I did was turn off the computer, go to the shop for awhile, and when I turned it back on, the reset button on the first Mach3 screen stopped flashing when I clicked on it! Just as it should... Thanks for the insightful suggestions , also ..I did not know that the gcode limit was per program, great news for me, cause my lathe turnings are fairly short and simple.(30-50 lines ea. so far){of course I don't really know if they will work until I actually get all the parts of the motors and drivers}Ha Ha, this waiting is killing me! They run nicely on the computer screen though.
Many Thanks,
Glenn