Messages

21

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 11:04:16 AM »

just ran it again and it says system excellent

22

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 11:03:15 AM »

that is correct

23

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 10:57:43 AM »

lol I wish I knew what that said. However the only devices shown connected in my control panel are wifi adapter , keyboard,moniter, pc and mouse.
I deleted the document writer because there is none.

24

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 10:46:06 AM »

when i click on devices in my control panel all it shows is a microsoft xps document writer and I'm not sure why that is

25

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 10:43:59 AM »

port 1 is enabled. port address is in question. axis is enabled. I'm pretty sure i have pins and ports correct. x=2,3 y=4,5 z=6,7
if i go into my control panel I'm not sure what I'm looking for. 

26

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 10:31:48 AM »

permanent green if I disable the ESTOP. Constant flashing when I set ESTOP port to =1

27

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 10:29:00 AM »

yes the DRO's are showing movement in + and - directions

28

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 10:27:03 AM »

Yes that is the board I have and both jumpers are jumped.

29

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 10:19:52 AM »

OK so, I ran jumpers from my +5 volt to the Enable + on each drive. I have a powerful hold on my ball screws but still no movement of any axis.

30

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 10:07:14 AM »

YAY! Little victories. By switching my A's and B's  I can no longer turn ball screws by hand. Still no movement of axis's though.  Enable+ huh? Let me run some quick jumpers.