Hello Guest it is May 10, 2024, 09:11:40 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - scooternauman

Pages: « 1 2 3 4 5 »
11
General Mach Discussion / Re: Newbie to cnc building in need of some help please
« on: January 20, 2019, 01:57:41 PM »
yes it appears to be doing just that

12
General Mach Discussion / Re: Newbie to cnc building in need of some help please
« on: January 20, 2019, 01:44:06 PM »
yes. p6-p7 are my z axis. no movement.
p to ground
motor controllers connected

13
General Mach Discussion / Re: Newbie to cnc building in need of some help please
« on: January 20, 2019, 01:38:51 PM »
yes with the 3.32 and 0.
Now keep in mind My breakout board is 5 volt

14
General Mach Discussion / Re: Newbie to cnc building in need of some help please
« on: January 20, 2019, 01:37:46 PM »
somethings amiss here. p2 on the breakout board is a steady 1.58 volts in both directions.
p3 is at 5.14 in the down dir. 1.58 in the up dir
p4 is at 1.54 in both dir
p5 is at 5.14 in the left dir 1.58 in the right dir
p6 is at 5.14 in to down dir 1.58 in the up dir
p7 is at 5.14 in the page down dir. 1.58 in the up dir
so it seems there might be an issue with p2 and p4?
What are your thoughts?

15
General Mach Discussion / Re: Newbie to cnc building in need of some help please
« on: January 20, 2019, 12:32:42 PM »
OK, so I just confirmed all pins 2-9 are working as they should according to that video. Although he was getting slightly over 4 volts my readings were a steady 3.32 volts.

16
General Mach Discussion / Re: Newbie to cnc building in need of some help please
« on: January 20, 2019, 11:39:21 AM »
Well I really appreciate all your help up to this point. We did make good progress. I'm gonna watch this video and put some food in my belly. I'll be back

17
General Mach Discussion / Re: Newbie to cnc building in need of some help please
« on: January 20, 2019, 11:33:15 AM »
yes

18
General Mach Discussion / Re: Newbie to cnc building in need of some help please
« on: January 20, 2019, 11:26:54 AM »
I/o Range 0378-37F
I/o Range 0778-077B
DMA 03     
  ??? is that what you mean?

19
General Mach Discussion / Re: Newbie to cnc building in need of some help please
« on: January 20, 2019, 11:23:18 AM »
what exactly am i looking for?

20
General Mach Discussion / Re: Newbie to cnc building in need of some help please
« on: January 20, 2019, 11:07:40 AM »
no port shown

Pages: « 1 2 3 4 5 »