Messages

11

FAQs / Re: Setting Mach 3 Port to PCI parallel port address

« on: November 20, 2018, 03:27:59 PM »

USB Motion Control Card 2MHz MK4-V

12

FAQs / Re: Setting Mach 3 Port to PCI parallel port address

« on: November 20, 2018, 08:15:57 AM »

Thanks for the prompt reply TPS...
Yes it is ☑️ But same issue...
I was made to understand that option is for a slave that uses the master homing switch, my machine has 2 home switches on the Y for squaring, so I tried it unchecked and same issue...
Not sure if it has anything to do with my DRO display, I’m running a 4 axis 4 drivers A&Y slaved Y being the master, X & the Z.. with a 3 DRO  XYZ I’m not sure how to get the A  DRO to display when I’m in plasma, if I change screens to mill I can see the 4th axis DRO...
 Thanks

13

FAQs / Re: Setting Mach 3 Port to PCI parallel port address

« on: November 19, 2018, 09:54:43 PM »

A Slaved to Y axis wont move period when ref all home but all ok in jog mode, THANKS & any help would be greatly appreciated...