1
General Mach Discussion / Digispeed problem
« on: January 15, 2019, 05:23:12 PM »
I have a strange problem, I have a Mini Mill X2 with a Digispeed DC-3 V3 to control my spindle, It had been working great, but today I found as soon as I start Mach3, my spindle starts up at full speed and can not be controlled. I have checked the configuration page and all is the same. The only way to stop the spindle is to either hit the E-Stop on the motor control or tick the Dir LowActive on the Motor Outputs page of the Pins and Ports.
Any one have any suggestions?
Thanks for the help
Jziz
Any one have any suggestions?
Thanks for the help
Jziz