11
Mach4 General Discussion / inputs and probes
« on: November 29, 2018, 03:53:06 AM »
Hi
I have ordered a ESS and C82
But I have been looking through the Mach4 software will I await its arrival and it occurs to me in the control panel the inputs section the Probe 0 to 3 probes are dedicated and can't be assigned to other inputs is that correct ?
If that is correct I assume the ESS smooth stepper board will also have the dedicated input to match
The same apply to E stop and the XYZ home switchs
is Probe able to use any input if so where do you configure it
Regards Ray
I have ordered a ESS and C82
But I have been looking through the Mach4 software will I await its arrival and it occurs to me in the control panel the inputs section the Probe 0 to 3 probes are dedicated and can't be assigned to other inputs is that correct ?
If that is correct I assume the ESS smooth stepper board will also have the dedicated input to match
The same apply to E stop and the XYZ home switchs
is Probe able to use any input if so where do you configure it
Regards Ray