1
General Mach Discussion / Re: Feed Rate is too slow when interpolating
« on: October 15, 2018, 07:43:27 PM »
Thanks.
I just did a test, and if I execute a simple circle command, it moves at full speed on a 1in circle. But if I do the x-y interpolation, it's slower. So it is capable of hitting the values from acceleration it seems if it's just doing a simple circle or line.
I bet you're right about the CV settting stuff. But I am hesitant to modify that and mess up the accuracy as you mention.
I just did a test, and if I execute a simple circle command, it moves at full speed on a 1in circle. But if I do the x-y interpolation, it's slower. So it is capable of hitting the values from acceleration it seems if it's just doing a simple circle or line.
I bet you're right about the CV settting stuff. But I am hesitant to modify that and mess up the accuracy as you mention.