7
« on: July 31, 2007, 11:53:45 AM »
I made a mistake I am using the mach 3. I will try to download the trial version tonight after work . I did watch the tutorial on installation several times . the driver test worked ok, the printer port is ok and checked but when i got to the motor outputs I am not sure if the rest of this is right. motor outputs are for xyz are all set the same step pin 3, dir pin 2 step port 1 dir port 1, input signals none are enabled port 1 pin 0 at the bottom of the page it stated that pin# 10-13 and 15 are imputs. at the output signals output 1 enabled all port # 1 all pin # 0 and at the bottom it says that 2-9,1,14,16,17 are output pins. I noticed that on the tutorial some of these had different numbers and I don't know how you know which number belongs where. I thought that the xlm patch would set this for me but it has not changed anything. thanks for your help.