Hello Guest it is March 28, 2024, 08:59:42 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - M.Step

Pages: 1
1
General Mach Discussion / Re: Newbie setting up Mach3 with ESS smoothstepper
« on: September 23, 2018, 01:25:29 AM »
So I measured the voltage between the +step and -step, same with +direction and -direction. When Mach3 is not running it is zero, when i turn on mach3 the voltages are 3.7V for all except 1 (4.3V).

I found a manual from leadshine that says the hi signal is at least 5V and the low signal is between 0-.5V. Is my low voltage causing the drivers not to enable? If so how do i increase the voltage?

2
General Mach Discussion / Re: Newbie setting up Mach3 with ESS smoothstepper
« on: September 22, 2018, 09:18:39 PM »
Yes. I Set them to the recommended setting that Longs motor sent me. Although i wasn't quite sure how those output pins were chosen.

On the Diagnostics tab, output signals  'enable 1,2,3,4' are red. When I press the estop they turn off.

The other thing I was wondering about was, should the drivers power on when I power on the system? Or should they power on when I turn on Mach3?

Thanks Gerry

3
General Mach Discussion / Newbie setting up Mach3 with ESS smoothstepper
« on: September 22, 2018, 08:16:50 PM »
Hi everyone,

I am currently building a CNC router and can not get the electronics to work.

I have a Longs Motor kit with a 1205 BOB and DM542a drivers and have wired everything according to the schematic they sent me (i have also seen this wiring work for other people). I have installed Mach3 Demo on my Windows7 64 bit PC, and I am using an ESS smoothstepper to drive the system.

The result is,
-the correct LED's are flashing on the ESS (top green LED is solid, bottom green LED blinks about 10 times per second, red LED lights up when estop is pressed). Mach3 says it detects the ESS upon startup.
-In Mach3 I am able to jog the axes, but I notice on the Diagnostics screen the Port 1 pins do not change to green when I am jogging.
-I checked the current at the BOB output pins, and it does not change when I jog the axes in Mach3
-the stepper motor drivers will not turn on (the green LED should be on)

I'm a complete newbie, but from what i understand Mach3 should be sending a signal through the ESS then the BOB that will enable the stepper drivers. I'm not sure what to change or what i am doing wrong but i hope it will be obvious to someone on this forum. It is pretty frustrating to be so close to completion of my build and yet be so far lol

I have attached some of photos of my wiring and mach3 settings.

Thanks in advance!

Mike

4
Hello
I'm Mike from Alberta Canada. I am currently working as a CNC machinist. Designed and built my first CNC router recently. Now I am having trouble with the electronics and software portion. So I am hoping to get some help from the more experienced users of Mach3.


Pages: 1