Hello Guest it is March 28, 2024, 03:52:40 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Okcsmurf

Pages: 1
1
General Mach Discussion / G Code Question
« on: September 17, 2018, 11:24:22 AM »
G code question
I have a code that makes a square 1.25 inch x 1.25 inch. I adjust the motor tuning setting to get it to 1.25 inch x 1.25 inch
I go to cut a circle that is suppose to be 1.00 it cuts it to 1.75 od. What can be causing this?

Pages: 1