Topics

1

General Mach Discussion / 0em functions

« on: June 18, 2011, 10:03:33 AM »

Hi
I need help wrinting a macro or some other method to use the oem #297 (reverese)
activated by a high or low input on oem#1 pin
how do I go about it.
Clive

2

General Mach Discussion / mach 3 latest download

« on: October 03, 2007, 11:38:08 AM »

Hi
I have a version of Mach3 on my laptop that runs a machine tool just fine. However I have had need to transfer control to a normal PC with a more than adequote spec and I cant get a peep out of the parrallel port its just as if its in Demo mode. I have set the port config to normal AT mode and improved the machines spec according to the update sheet. The only difference is this version of mach 3 was downloded very recently after lockdown. Has the printer driver option been removed from the install page as i dont recall seeing it when installing the most recent download.
Regards
Clive

3

VB and the development of wizards / Getting started with VB

« on: July 26, 2007, 02:08:16 AM »

Hi
Can anyone point me in the direction of a document or listing on how to interface with mach 3 with a view to adding VB extras.
regards
Clive