Topics

1

Forum suggestions and report forum problems. / Search Function Error Message

« on: November 08, 2018, 04:16:45 AM »

I am using Chrome as my default browser and when I try to use the search function i get the following error.

2: pspell_new(): PSPELL couldn't open the dictionary. reason: No word lists can be found for the language "en".
File: /var/www/vhosts/machsupport.com/forum.machsupport.com/forum/Sources/Search.php
Line: 700

I am aware that this is probably not a forum issue but an issue with my setup.  Obviously I can't use the search function to check if this has  been mentioned before so I apologise if I am repeating a Post.

If anyone can give me any pointers as to where to look for a solution I would be grateful.

Many thanks

Sorry, Sods Law, Just spotted a similar post answered by Tweakie, the problem is still around.

2

General Mach Discussion / Fitted new spindle

« on: October 06, 2018, 04:12:24 PM »

Hi everyone,
My question is a simple one , I used to zero the Z axis using the probe go to zero feature,  before each zeroing I did a check to make sure that the green digitize light came on when I touched the bit. I have fitted a virtualy identical spindle and now when I do the green digitize test the light does not come on.  I have not changed any of the settings. Has anyone had a similar experience? Or does anyone know why? I  have a Chinese 3040T that I use just for fun. Is it back to the piece of paper or can you help?
Many thanks
Eugene