Messages

21

General Mach Discussion / Re: Newbie who needs a direction with Mach3.

« on: August 10, 2018, 03:12:28 AM »

Yes the main issue was fixed after new install, still need to sort out vfd speed, will wait till i get new ATC spindle and vfd. Up until then i will manually start spindle.

22

General Mach Discussion / Re: Newbie who needs a direction with Mach3.

« on: August 08, 2018, 04:32:16 AM »

Thank you for your reply. I have a issue as the spindle speed goes up so does the speed of X and Y, to the point I shut down as the movement is very erratic plus the vfd is pulsating at low speed and at the same time also the x and y. regards Stuart

23

General Mach Discussion / Newbie who needs a direction with Mach3.

« on: August 08, 2018, 04:04:08 AM »

Hi there  newbie here I have a Maxi cut 1325 table I am running Win7 32bit.
Revolutionary 3 Axis Mach3 CNC USB Motion Controller Card 200KHz Stepper Servo. From Ebay
Compatible 3.7 hp air cooled spindle with a Delta VFD.
I had a friend help convert over from a DSP controller. I am having an issuue with the vfd pulsing for a start and a different readout from mach3 to vfd panel
 xyz are working.
I would like to reinstall Mach3 correctly from the start again, and get rid of all the bugs. Where should I look for documentation and help.
All help appreciated. regards Stuart  

24

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: August 08, 2018, 03:43:55 AM »

Hi there My name Is Stuart I am from Australia I just purchased a license for mach3.