Hello Guest it is December 04, 2021, 09:50:41 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - lumber60

Pages: « 1 2 3 4 5 6 7 8 9 10 11 »
51
Mach4 General Discussion / Re: Font gngrave wizard
« on: November 08, 2018, 12:11:08 PM »
Hello Stuart,

The screen display looks fine, its the actual cut that laps, touches etc, they cut into the edge of the previous letter. There must be something i am not doing or doing wrong!!!

Ken

52
Mach4 General Discussion / Re: Font gngrave wizard
« on: November 08, 2018, 07:44:54 AM »
I watched the utube link and i have watched it several times previously to see if i was missing something. The issue i have is the auto calculator for font size always sets the font just overlaping each letter slightly no matter how big or small i set it.

I am using the straight line font provided

How can change this letter spacing?


Ken

53
Mach4 General Discussion / Re: Font gngrave wizard
« on: November 08, 2018, 07:25:32 AM »
Thanks for the clairifacation. I hope i am in trhe right spot now. When you get to my age you always hope your in the right place.

Thanks again

Ken

54
Mach4 General Discussion / Re: Font gngrave wizard
« on: November 07, 2018, 01:47:58 PM »
So i signed up for a tweakie account, am i understanding that i shouldn't use mach support anymore??

Ken

55
Mach4 General Discussion / Re: Topic moved
« on: November 07, 2018, 10:48:34 AM »
My topic has been moved to tweakie!

What does that mean????

Ken

56
Mach4 General Discussion / Font gngrave wizard
« on: November 07, 2018, 10:06:13 AM »
Has anyone used the font engrave wizard in mach 4?
 I need to know how to set font / type spaceing to engrave properly. Any help would be great.

Ken

57
Mach4 General Discussion / Re: New Forum!
« on: November 06, 2018, 01:47:35 PM »
How do i get to new forum / use search etc. Have tried and search always comes back with errors, doesn't recognize language????

Something has deffinetly changed!!!

I can't figure it out

Ken

58
Anyone else having trouble searching topics

59
I am very pleased with the Mach 4 that Craig, as well as everyone else that talked me through earlier this year! I am checking out different buttons all the time and working thrtough them. If I can get this font engrave to work my wife will smile again Ha Ha. Have cut a buync of test pieces to get the feel, now it is time for the real deal and i have trime to stay with it and do it.

I have tried diffefern bits with no success the font cuts and touches the previous letter no matter what dimension i use.

Any ideas please let me know.

Ken

60
Thanks, how about spacing between letters etc??? Is that possible? When i run it the letters overlap right at the edges

Ken

Pages: « 1 2 3 4 5 6 7 8 9 10 11 »