Hello Guest it is March 28, 2024, 02:32:33 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - signweld

Pages: « 1 2
11
General Mach Discussion / Mill works normally, but plasma acts odd.
« on: March 17, 2014, 07:32:00 PM »
I am up and running Mach3.  I open the "Mach3 loader icon on my desktop, choose Mach mill, it loads up and all is well. runs as it should be.
  If I Choose Mach plasma, it opens  up. I have it configured the same settings as in "mill" version but jog does'nt work correctly. The Y axis is reversed direction and runs slow. When I press the cursor key to move in the X axis the Z goes up and down. Pressing pg up or down to move z, nothing happens. Now I'm totally confused. Im sure I missed a setting correctly, Have been puzzled for a week, and run out of ides of what to search the forum topics for.
Paul M.

Pages: « 1 2