Messages

1

General Mach Discussion / Re: licence code install

« on: August 09, 2018, 02:09:23 PM »

Thank you so much for your quick response

2

General Mach Discussion / Re: licence code install

« on: August 08, 2018, 10:58:43 PM »

Hi everyone. I'm running Mach 3 demo. My CNC machine is on a computer that is not hooked to the internet. If I buy the license and it is sent to my computer that is hooked to the internet will I be able to transfer it to my other computer? Thanks for your help

3

G-Code, CAD, and CAM discussions / Re: help with mach 3 not running at g coded feedrate

« on: April 11, 2018, 02:30:14 PM »

Good afternoon Tweakie. Last night I uninstalled Mach 3 and reinstalled it. Loaded a G code file that I used before with no problems  The project shows up in the display screen so small you cant hardly see it. I run the axes test for X & Y entered 24.5 and it moved 1". When I run the file the router does not hardly move and I'm running in inches. Rechecked my settings and everything set to the settings for my router. Don't know what to do now. This unit was working great at one time before the cat walked across the key board. Took the computer to repair shop and they said everything was fine.

4

G-Code, CAD, and CAM discussions / Re: help with mach 3 not running at g coded feedrate

« on: April 09, 2018, 01:27:22 PM »

Still no luck.

5

G-Code, CAD, and CAM discussions / Re: help with mach 3 not running at g coded feedrate

« on: April 03, 2018, 11:16:34 PM »

Hi Tweakie.
Thank you so much for your reply. My projects are in inches and this is the way I have Mach 3 set up. I did try entering G21 just to make sure. Nothing has change. As soon as I can figure out how to do it I will upload a photo of my screen. In my diagnostic screen when I push the up arrow key I do not see any LED's light up, only when I set the E stop. Also in Port 1 pins current state I have 5 LED's in the upper row showing green.

6

G-Code, CAD, and CAM discussions / Mach 3 Display window not showing the correct size of project

« on: April 02, 2018, 09:17:30 PM »

Can someone help me? I'm retired and bought a Cheap Chinese 3040 CNC router. It was running fine I did two nice name plates with it. Don't know what happen but the G-code fonts got small and the display window does not show the project in the correct size.  Checked all my pin & port setting nothing has changed. So I uninstalled Mach 3 and reloaded the program
Same thing is going on. In settings I run inches the X,Y,Z all move 1". Load the G code and the same thing. Project is so small you can not see it on the display. Under last wizard box a yellow box says Abnormal condition I J mode absolute. So I downloaded Mack 3 trial version again and installed it and everything is the same. HELP