Topics

1

General Mach Discussion / Change speed with butons (not mouse)

« on: February 03, 2009, 12:15:13 AM »

Can do some with screen designer , and set two buttons for change speed in work ?

The best solution is & mouse & buttons ( +,-  ...?)

Thanks

2

General Mach Discussion / G04 Pxx , and how can set aouto on enable out pin ?

« on: November 06, 2008, 07:12:25 AM »

G04 Pxx , and  how can set aouto on enable out pin ?

I need one  enabled out pin when is G04 in progress, but , is possibile set in MACH3  or some else for it


I have big brener MESSER , and have PP where is code perfect, but  need that function on G4...

can in PP set some  on line G04 Pxx M100 or M200 (for enable out pin) , if MACH3 can do it ?

Thanks

3

General Mach Discussion / G4 PX & output signal

« on: October 27, 2008, 01:14:24 PM »

How can set comands G4 Px , and output signal inside stop time ?

4

Mach Screens / Sample screen 3-axis

« on: April 17, 2006, 03:39:15 PM »

unrar in Mach3 folder
copy picture in Millbackgrund folder
load  set file

5

General Mach Discussion / Limit overide ...Hotkey ..how ?

« on: April 11, 2006, 04:51:09 AM »

I try set key for "override" when  limit is activ,...but nothing hapend when press button (like CTRL+L...)

i can find in manual nothing about that ...hoe set limit override ?
MACH3

THX

6

General Mach Discussion / LIMIT I/O how ?

« on: March 27, 2006, 03:22:39 AM »

Im controled before on turboCNC , and now can problem how diseble  drives (pin 16) and configure LIMIT SWITCH   ...8 END LIMIT on axis, and 8 for manual like offset on stock  etc...

can some explain me  how can do  that ?

have 5VDC  (LM7805) optocooupler 16 ch, and 12VDC for relay ...
potencial of ZERO not problem, only  port-pin configuration...

is P3 933 Mhz , enuagh for MACH 3 on 25kHz ?