Hello Guest it is April 23, 2024, 10:33:37 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - rossmartin

Pages: 1
General Mach Discussion / laser/impact engraver
« on: July 17, 2007, 11:26:56 PM »
Thanks in advance. I'm getting an output on the digital trigger (port 1
pin 14) when I have the laser trigger turned on and the grid set to any
value (x=n) (y=n). When I load the plugin it runs just like it should, but when it
starts the scan I don't get any output pulses on my scope without the
laser trigger turned on. Then the pulse train only follows the values
that are entered into the grid parameters not the greyscale image. 
What am i missing? I would like to use my laser (TTL trigger) with M3
Thanks so much for everything.
Ross Martin

Pages: 1