101
General Mach Discussion / Re: Only X-axis motor is working
« on: March 18, 2018, 11:40:57 PM »
Thanks. Will give it a shot.
One of the tutorials I watched on youtube showed that there needed to be both because of a bad bridge on the board. He was showing where to run a jumper.
I will pick up a USB cable and give it a shot.
Thanks
One of the tutorials I watched on youtube showed that there needed to be both because of a bad bridge on the board. He was showing where to run a jumper.
I will pick up a USB cable and give it a shot.
Thanks