Guest
Show Posts
1
General Mach Discussion / MACH 3 RECOGNIZING HOME SWITCH BUT NOT STOPPING
« on: March 15, 2018, 06:52:08 PM »
After 3 days of reading things on here, and trying those settings... I’m at a loss....
MACH 3
Win XP
Leafboy77 controller (USB)
Jcut 1325 machine
Machine has ran fine for 2 years.... went in the other day to cut something and all of a sudden it would not home. When I hit REF ALL HOME, the machine goes right past the the home/limit switch, light comes on in diagnostic screen, so it does recognize it, but it continues on and crashes into stop... I have adjusted debounce. And pretty much everything I’ve read on here in the last 3 days(which is a lot of info) and it has changed nothing. Any help would be greatly appreciated
MACH 3
Win XP
Leafboy77 controller (USB)
Jcut 1325 machine
Machine has ran fine for 2 years.... went in the other day to cut something and all of a sudden it would not home. When I hit REF ALL HOME, the machine goes right past the the home/limit switch, light comes on in diagnostic screen, so it does recognize it, but it continues on and crashes into stop... I have adjusted debounce. And pretty much everything I’ve read on here in the last 3 days(which is a lot of info) and it has changed nothing. Any help would be greatly appreciated