Hello Guest it is April 24, 2024, 06:00:43 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Greg F.

Pages: « 1 2 3 4 »
21
Mach4 General Discussion / Re: Auto tool zero...Z-probing
« on: March 03, 2019, 12:19:20 PM »
Ok also let me double check to make sure my
STEP PER UNIT is correct

22
Mach4 General Discussion / Re: Auto tool zero...Z-probing
« on: March 03, 2019, 11:29:40 AM »
The button I'm using is the AUTO TOOL ZERO...

23
Mach4 General Discussion / Re: Auto tool zero...Z-probing
« on: March 03, 2019, 11:09:28 AM »
Did you mean the script...

24
Mach4 General Discussion / Re: Auto tool zero...Z-probing
« on: March 03, 2019, 08:10:26 AM »
Is it better to use inches..

25
Mach4 General Discussion / Re: Auto tool zero...Z-probing
« on: March 03, 2019, 02:23:13 AM »
I have Ess smoothsteooer with bob MB2
And using mm..using the auto tool zero button
From mach4..yes I tried MDI

26
Mach4 General Discussion / Auto tool zero...Z-probing
« on: March 03, 2019, 12:05:38 AM »
Ok need some help I'm new to mach4..
When I go to z probe it doesn't go down I have
To get it about 1/16 above  for it can touch it
Maybe I'm doing something wrong ..and also if
I send it to cut it stays high above the surface...

27
Mach4 General Discussion / Re: Auto tool z- probe
« on: January 03, 2019, 11:44:32 PM »
It's working now thanks

28
Mach4 General Discussion / reference home
« on: January 03, 2019, 11:40:22 PM »
Need little help when i reference home all axis they go pass my limit sensers
Is there something else I have to do
I'm using  Ess build 232 and mach4 3804

29
Mach4 General Discussion / Auto tool Zore
« on: January 01, 2019, 08:36:56 PM »
Need help when I press auto tool zero to probe the z hight
I get nothing.. like to know is there anything else I have to do..

30
Mach4 General Discussion / Auto tool z- probe
« on: January 01, 2019, 02:11:53 PM »
To start i have Ess build 232 with Mach4 version 3804
 
  OK on my brake out board when I touch the 2 wires for probe the led goes on,
On my board but I don't see it go on in the mach4 screen don't understand why before
It worked..I'm new to this ..can someone help thank you for your TIMES.......

Pages: « 1 2 3 4 »