Messages

1

Mach4 General Discussion / Re: Steps per unit wizard

« on: April 25, 2019, 11:13:03 AM »

When I press ok I get this message
Lua:Syntax error during  pre-compilation

2

Mach4 General Discussion / Re: Steps per unit wizard

« on: April 25, 2019, 08:59:44 AM »

Yes ..but is not working right now

3

Mach4 General Discussion / Re: Steps per unit wizard

« on: April 25, 2019, 07:16:12 AM »

I'm using MB2 Bob with ESS...
If you have mach4 look at that wizard
Button ...

4

Mach4 General Discussion / Steps per unit wizard

« on: April 24, 2019, 09:01:11 PM »

I try to use the steps per unit wizard
And is not working or maybe I'm doing
Something wrong...I'm using 4.2.0.4162...

5

Mach4 General Discussion / Re: Mm back to inches

« on: April 08, 2019, 07:43:00 PM »

Ok thanks..for your help

6

Mach4 General Discussion / Mm back to inches

« on: April 08, 2019, 06:55:09 PM »

Like to know if I'm in mm in mach4 and I want to make it inches do I have to recalibrate...

7

Mach4 General Discussion / Re: Re: Auto tool zero...manual tool change

« on: April 04, 2019, 08:37:31 PM »

Oh ok thanks ..I'll try it again..

8

Mach4 General Discussion / Re: Re: Auto tool zero...manual tool change

« on: April 04, 2019, 07:55:14 PM »

The G91 Z-××.x") --xx.x=
Is the x spouse to mean something...

9

Mach4 General Discussion / Re: Re: Auto tool zero...manual tool change

« on: April 04, 2019, 07:28:54 AM »

Ok I'll try that..thanks

10

Mach4 General Discussion / Re: Re: Auto tool zero...manual tool change

« on: April 03, 2019, 09:58:49 PM »

I will take a look at DTZ videos..hoping I can get it right...